The 4th field of display should switch to ADP OK once it has completed.
![vcds transmission adaptation reset vcds transmission adaptation reset](https://www.totalcardiagnostics.com/shop/image/cache/data/vagcom-hex-v2/20.4.1-about-no-vcdsloader-600x600.png)
Kick-down Blee or 10 times may be displayed before holding the pedal to the floor. Press accelerator pedal all the way to the floor. Note: Most Drive-by-Wire (DBW) throttle systems support the Kick-Down Basic Settings procedure.Įngines using KWP-2000 or CAN will have the button.
#Vcds transmission adaptation reset how to#
Bold type states how to avoid the hazard. It is normal for there to be no explicit instructions or changes on the screen when you do the above procedure. iv Safety Information Important Safety Instructions Safety messages contain th ree different type styles.Press accelerator pedal all the way to the floor and hold for 3 to 5 seconds. Throttle must be at idling position (keep your foot off the gas pedal).Throttle Body Alignment (TBA) performed successfully when applicable.No DTC's in the Engine or Transmission Controller.TCM has been removed and reinstalled or replaced.After Engine and/or Automatic transmission repairs.Accelerator Pedal has been removed and reinstalled.Throttle Body has been cleaned or removed and reinstalled.ECM has been removed and reinstalled or replaced.
![vcds transmission adaptation reset vcds transmission adaptation reset](https://img.yumpu.com/38543816/1/500x640/vcds-release-106-pdf-manual-printing-instructions-website-van-.jpg)
![vcds transmission adaptation reset vcds transmission adaptation reset](https://www.obd2tool.com/blog/wp-content/uploads/2021/11/How-to-Adjust-the-Service-Oil-and-Inspection-by-VCDS-2-768x403.jpg)
(Transmission should be warmed up already before doing this) 2)Go to 02 - Electronics & Measurement Group / Basic Settings > Group 60 > Read 3)Wait for fields to display the following information: 4 - 0 - 0 and then start engine in next 10 seconds.
#Vcds transmission adaptation reset manual#
Check the procedures on the applicable vehicle-specific Wiki pages in the Diagnostic Procedures section or the Factory Repair Manual for additional information. Some TCMs support a Kick-Down procedure and others do Not. Ross-Tech is not responsible for any damage or problems that may result from following these instructions.